Castalia - 用户手册
Introduction - 简介
Why a new simulator? - 为何要创建一个新的仿真器
Overview -概览
Structure - 结构
Using Castalia - 使用Castalia
假设你已经成功安装OMNeT和Castalia。可以参考安装指南了解安装细节和疑难解决。由于Castalia 3.0的发布，对输入输出的处理已经改变很多了。即使你有使用Castalia 2.3b或者之前的版本的经验，我们仍然建议你读读这一章节。Castalia 3.0中有两个脚本来帮助跑仿真和解释结果。他们分别叫做Castalia和CastaliaResults。在Castalia 3.1中我们还有CastaliaPlot来帮助画图。这些脚本均位于Castalia/bin目录下。仿真器的可执行程序位于Castalia/下的CastaliaBin，但是你不用直接调用它。
We assume here that you successfully installed both OMNeT and Castalia. Refer to the Installation Guide for details and troubleshooting. Since the release of Castalia 3.0, handling of input and output has changed considerably. We advise you to read this section even if you had previous experiences with Castalia 2.3b or earlier releases. Since Castalia 3.0, we have two scripts to help with running simulations and interpreting the results. They are called Castalia and CastaliaResults respectively. Since release 3.1 we also have CastaliaPlot to help you create graphs. They all reside in Castalia/bin/ . The executable of the simulator is called CastaliaBin resides in Castalia/ but you will not need to invoke it directly.
Running the first simulation - 做第一次仿真
Understanding the configuration file - 弄懂配置文件
Using the Castalia and CastaliaResults scripts - 使用Castalia和CastaliaResults脚本
Using CastaliaPlot to create graphs - 使用CastaliaPlot画图
Advanced usage - 高级用法
Manipulating the display of a results table
Multiple repetitions and confidence intervals
Changing configurations at command line
Complex simulation examples
Body Area Network simulation example
Bridge Test simulation example